1. 中科聚峰礦井車設備

        • 服務熱線:

          15065707252

        當前位置:首頁 > 新聞中心 > 客戶反饋 >

        新聞中心

        服務熱線電話

        15065707252

        裝載機如何快速換輪胎?

        來源:http://www.socialsecurityutah.com/ 發布時間:2022-07-04 瀏覽次數:200

        內容詳情:
        由于小型裝載機在比較惡劣的工地(比如巖石面)工作時經常發生爆胎,小型裝載機廠家總結出一條快速更換裝載機輪胎的方法,具體如下:
        Since small loaders often have flat tires when working on poor construction sites (such as rock surfaces), small loader manufacturers have summarized a method to quickly replace loader tires, as follows:
        (1)首先啟動機器,然后尋找一塊平坦開闊的場地,壓下動臂升降桿,利用動臂支撐使前輪離地,然后用支架支撐在閃橋靠近爆胎的一側,并將后輪楔好。
        (1) First start the machine, then look for a flat and open place, press down the boom lifting rod, use the boom support to lift the front wheel off the ground, and then use the support to support it on the side of the flash bridge near the flat tire, and wedge the rear wheel.
        (2)利用撬杠等工具,拆卸擋圈及鎖圈然后檢查輪胎襯墊與輪輞外表面是否粘連。若發生可撤掉支撐物,使機器在短距離內慢速往復運行,直至襯墊與輪輞外表面脫離;嚴禁轉向和高速行駛,以免損壞內胎。然后,前輪重新支撐起來。
        (2) Use pry bars and other tools to remove the retaining ring and lock ring, and then check whether the tire liner is adhered to the outer surface of the rim. If it happens, the support can be removed to make the machine run back and forth slowly in a short distance until the gasket is separated from the outer surface of the rim; It is strictly forbidden to turn and drive at high speed to avoid damaging the inner tube. Then, the front wheels are propped up again.
        (3)將內、外胎的相對位置作好標記,以便查找、清除異物和修補輪胎。
        (3) Mark the relative positions of inner and outer tires to find and remove foreign matters and repair tires.
        (4)利用撬杠等工具,將輪胎從輪輞上拆下。注意,動作要輕柔配合要默契,避免被輪胎砸傷,并且要保護好氣門嘴。
        (4) Use pry bars and other tools to remove the tire from the rim. Note that the action should be gentle and tacit, to avoid being injured by the tire, and to protect the valve mouth.
        (5)外胎被釘子等細長異物扎傷后,若表面無明顯創口或創口較小,則此外胎可繼續使用(因為裝載機輪胎屬低壓胎,且運行速度比較慢);若創口較大,則進行修補(因為機器運行時,輪胎受擠壓磨擦,時間一長會損壞內胎,甚至創口越來越大、內胎突出,造成輪胎報廢。
        (5) After the outer tire is stabbed by slender foreign bodies such as nails, if there is no obvious wound on the surface or the wound is small, the outer tire can continue to be used (because the loader tire is a low-pressure tire and the running speed is relatively slow); If the wound is large, repair it (because when the machine is running, the tire is squeezed and rubbed, and the inner tube will be damaged over time, or even the wound will become larger and larger, and the inner tube will protrude, causing the tire to be scrapped.
        (6)若是新內胎,將氣門嘴底部的螺栓擰緊,以防漏氣;然后將外胎內腔的異物清除,并撒入適當的滑石粉,涂抹均勻。為了使襯墊與內、外胎貼緊,在裝入內胎后應給內胎適當充氣,再塞入襯墊。
        (6) If it is a new inner tube, tighten the bolts at the bottom of the valve to prevent air leakage; Then remove the foreign matters in the inner cavity of the outer tube, sprinkle appropriate talc powder, and apply evenly. In order to make the liner close to the inner and outer tubes, the inner tube should be properly inflated after installation, and then the liner should be inserted.
        (7)將輪胎裝到輪輞上,裝上鎖圈、擋圈;安裝過程中要保護好氣門嘴。
        (7) Install the tire on the rim, and install the lock ring and retaining ring; Protect the valve nozzle during installation.
        (8)用車載空壓機給輪胎充氣。
        (8) Inflate the tires with on-board air compressor.
        (9)壓下動臂升降桿,取出支架;至此換胎完畢,整個過程大約需要50min。
        (9) Press down the boom lifting rod and take out the support; At this point, the whole process takes about 50min.
        更換后輪胎時,則需要另一臺裝載機或者其他起重設備輔助,將后輪胎支撐起來,其他程序則與更換前輪胎相同。
        When replacing the rear tire, another loader or other lifting equipment is required to support the rear tire, and other procedures are the same as those for replacing the front tire.
        以上就是為大家介紹的有隧道裝載機的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務.http://www.socialsecurityutah.com
        The above is a detailed introduction to the tunnel loader, which I hope will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.socialsecurityutah.com
        久久精品国产2020观看福利